BS EN 14314:2015. Thermal insulation products for building equipment and industrial installations. Factory made phenolic foam (PF) products. Specification

BS EN 14314:2015. Thermal insulation products for building equipment and industrial installations. Factory made phenolic foam (PF) products. Specification

All BSI publications are supplied as PDFs only, sent by email following receipt of your order. Please allow up to 24-48 hours (1-2 working days) for delivery.

What is BS EN 14314 - Factory made phenolic foam (PF) products about?  

BS EN 14314 is the European standard for thermal insulation products that consistently offer the intended resistance to heat flow throughout the building's lifetime. 


BS EN 14314 specifies the requirements for factory-made phenolic foam products which are used for the thermal insulation of building equipment and industrial installations with an operating temperature in the range of approximately - 200 °C to + 120 °C. 


Below an operating temperature of - 50 °C, special tests regarding the suitability of the products in the intended application are advised (e.g., liquefaction of oxygen). The manufacturer’s advice should be heeded in all cases. 


The products are manufactured in the form of blocks, faced or unfaced, boards, pipe sections, segments and prefabricated ware. 


BS EN 14314 describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling. 


Products covered by BS EN 14314 are also used in prefabricated thermal insulating systems and composite panels, the performance of systems incorporating these products is not covered. 


Note 1: BS EN 14314 does not specify the required level of a given property that should be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application can be found in regulations and invitations to tender. 


Note 2: Products with a declared thermal conductivity greater than 0,050 W/(m·K) at 10 °C are not covered by BS EN 14314. 


Note 3: BS EN 14314 does not cover products for in situ insulation (blowing or pouring) or products for the insulation of the building structure. 


Note 4: BS EN 14314 does not cover the following acoustical aspects: direct airborne sound insulation and impact noise transmission index. 

£0.00
£290.00

QTY Minimum order quantity 1. Maximum order quantity 10


Share the love with your friend

Complete the form below and we'll email your friend about this product


You’ll earn 0 reward points with this purchase.

Be one of the first to know!

We’re sorry we’re out of stock but we can let you know as soon as it's available if you enter your email address below.